|
Details: |
|
UFP by
Dexter Stainless Steel Ventilated Rotor With Aluminum Caliper Kit - K7181100
Zinc+ is the most corrosion resistant coversion
coating to be introducted to the metal finishing industry. This coating can
provide over five times the protection when applied over zinc plating.
3,750 lb. brake force
One Wheel End Kit
Kit Includes
- Stainless steel rotor
- Aluminum caliper with aluminum piston
- Dacromet coated brake pad plate anchor
yoke
- Stainless steel slider pins, pad guides, and
anti-rattle springs
- Stainless steel banjo bolts and bleeder
screws
- (2) Copper washers
- (3) Caliper mounting bolts
- Dexter spacer bracket
Note: All 3.7K Non-Integral Disc Brake Kits
include a caliper mounting spacer bracket. This spacer is ONLY necessary
when the disc brake kit is used in conjunction with all Dexter Axle 008-248
idler hubs. The spacer is essential to accommodate for the unique internal
bearing placement of the Dexter hub.
Additional Features
- No left hand or right hand calipers
(Fittings are shipped loose allowing the installer the ability to use
caliper on either side. When mounting calipers, the bleeder screw position
should always be on top to allow proper bleeding)
- Ventilated rotors for temperature regulation
to reduce brake pad deterioration, excessive wear and warping
- Non-metallic, non-asbestos, organic pad
materials to eliminate corrosion
- Disc brake caliper to be used with 13"
wheels and larger
- Inlet/outlet port positions decrease amount
of air in the system through a large range of torsion arm trailing angles
- Braking forces are transferred to the
yoke/anchor bracket and not the caliper slide pins
|
|
Did you Know?
ALL products we sell are factory new and come with the full Manufacturers Warranty! |
|
|
